Thank you for viewing this product. Please read the profile section before purchasing. -------------------------------------------------- This is a listing for [Mini 4WD Catcher Damper]. ■ Cut from Tamiya genuine Mini 4WD catcher, black. You can use it without restrictions from daily practice to Tamiya official competitions. -------------------------------------------------- [Product Details] * Total length → Approximately 60mm * Center of mounting hole to rear end → Approximately 35mm * Can be used for the popular MS FlEX, FM-A chassis, etc. * Sufficient effect can be expected with a light weight of about 1g to 1.5g! * This is a long-stroke type catcher damper that is mounted using the position of the rear bumper mounting hole. * The included tension plate can maintain the initial position of the catcher. Also, it can prevent excessive bending downwards, so please use it to adjust the traction to the chassis. * Uses genuine catchers. Please note that vertical creases may appear as shown in image 7, or the product's letters and pressed patterns may be randomly included as shown in image 8. You cannot specify the cutting position. * The images are samples. Please note that the cutting position may not be the same. * Tamiya genuine catchers other than black are also cut in limited quantities. If you wish, please be sure to consult in the comments before purchasing. The production colors are the 5 colors in image 9. * From the following tag to the Mini 4WD product list ↓↓↓ #tsumugu's Mini 4WD related listings * Click here for a list of typeH products only ↓↓↓ #CatcherDampertypeH -------------------------------------------------- [Handmade by an individual.] There may be individual errors in size, cut lines, and hole positions. Also, there may be fine fluffing left over from cutting, so please understand. Please refrain from purchasing if you are overly concerned. Please purchase only if you can agree after confirming the images. Please ask if you have any questions. [Search Keywords] Tamiya mini4wd Mini 4WD Catcher Damper Mass Damper Double Shaft Single Shaft [Management No. 159]