Thank you for viewing. This is a newly released product. This product is a mount for attaching the SESAME 5 (Sesame 5) with magnets. The SESAME 5 main unit is not included. This product is custom-made after you provide the height of your thumbturn. After purchase, please specify the height from the door surface to the top of the thumbturn in 1mm increments on the transaction screen. (Standard production range: 25mm-55mm; other ranges may require additional adapters, so please consult before purchasing.) By using this product, you can install the SESAME 5 vertically or horizontally with magnets. We use large and powerful neodymium magnets (with yoke), so it will firmly adhere to the door. It will not shift even during the locking and unlocking operations of the SESAME 5. We have designed it so that you can replace the batteries while it is installed. It is easy to remove, so it is also recommended for rental properties. 【How to Measure Dimensions】 Measure the height from the door surface to the top of the thumbturn with a ruler or calipers. If the height is difficult to measure, match it to the roughly measured dimensions, cut out cardboard, and then apply it to the thumbturn to confirm the height. (To prevent contact between the Sesame 5 and the thumbturn, we will manufacture it with a 3mm gap.) In the unlikely event that there are problems such as the dimensions not fitting and not being able to be installed, we will remake it at the minimum Mercari price, so please feel free to contact us. 【Installation Method】 Attach the double-sided tape included with the SESAME 5 to the mount. Align the center of the thumbturn and the rotation center of the SESAME 5, and install it on the door. - Model: SESAME 5 - Material: Biomass plastic - Mounting method: Magnet - Installation examples: Vertical and horizontal installation possible ※Please note ・Please check in advance that the magnet will stick to the door. It cannot be used on aluminum or wooden doors. ・This product is made by a 3D modeling machine. There are no problems in use, but it will not have the strength and finish of general injection-molded industrial products. Some unevenness and layering marks may occur. ・It softens at 60 degrees Celsius or higher. We do not recommend using it in direct sunlight or in places with high temperatures. Smart Lock Candy House