This is a sticker refill made by processing double-sided release paper into an A7 size binder. Since you can stick stickers on both sides, you can store a lot of them. ・A7 6-hole dedicated refill 　Double-sided release paper for stickers × 10 sheets 　(Size: Approximately 12.7cm tall × 9.5cm wide) ・A7 6-hole dedicated refill cover × 10 sheets Because it uses release paper used for sticker backing, you can easily stick and peel off paper stickers and stickers. It's the perfect refill for sticker swaps and sticker books! I made a backing cover for sticker books. When swapping stickers, you can flip the cover without removing it from the binder, and when you're done, just snap the cover back on (no need to remove the binder when putting it back). Both also prevent stickers from getting dirty. Since the cover can be flipped open, it does not completely prevent stickers from falling out. It can prevent stickers from getting dirty. If the stickers are quite thick, they may lift up and the slits may open on their own. There are burrs on the holes of the cover, but there is no problem with use, so they will be shipped as is. 【Requests】 ・I've tried it with various stickers, and some stickers peel off easily and some stick firmly depending on the type and manufacturer. Please try it out little by little. ・Since it is made by hand from cutting to hole punching, there may be some slight deviations. Please understand this before purchasing. ・Fine dust and particles may be mixed in during the release processing. Please understand. ・The sticker backing and cover are made in different processes, so there may be some misalignment of the holes, but it can be used without any problems when attached to the binder. (Photo 6) ・Binders and stickers are not included.