Thank you for viewing. Ready for immediate dispatch. This time, shot blasting has been added only to the mounting part. Please refer to the images. Details are listed below. Please read to the end. Rear carrier for the 3rd generation Hayabusa. Made of SS (steel), powder coat finish. Please refer to the images for the shape and mounting condition. The last image is what you will receive. About Installation It uses the same method as the original tandem bar. Simultaneous installation of the grab bar is also possible (processing on the grab bar side is required). Remove the spacers used for the original tandem bar, and insert the included spacers. Use the original bolts. There is also a gap with the seat cowl, so it will not interfere with the vehicle body. *There is a possibility of interference depending on individual differences* Various boxes can be installed (COOCASE, GIVI confirmed) Modern boxes can also be installed. The size is 55L. The grab bar can also be removed in this state. I hope this is helpful. Load capacity is estimated to be around 8-10 kg (approximate). I tried lifting the Hayabusa with a ceiling crane, only from the rear. The total vehicle weight is 264kg (catalog value), and since it's only the rear, I feel like it's about 1/4 or 1/5 of the weight, but it has that kind of strength. Top plate 4.5t Vehicle body side mounting base plate thickness 9.0mm Ground contact plate thickness with top plate 4.5t 12.0mm It's made quite sturdy. I think you'll understand when you hold it in your hand. About Shipping Shipped by Sagawa Express, prepaid. Other shipping methods are not available. About Packaging Materials Recycled materials may be used. Air mat + wrapping cardboard is planned. Please understand. Although it is new and unused, there may be scratches that occur during material processing or manufacturing. The shape and specifications may change without notice. Please understand. Thank you for your consideration. Manufacturer...Suzuki Vehicle type...GSX Model...GSX1300R Hayabusa *Please use this as a reference, as it is not a part for lifting the vehicle. *The load capacity is not guaranteed because it differs between surface load and point load. *The carrier during lifting was an unpainted product.