★ Compared to the normal version, the low-frequency gain and response have been increased, and the high frequencies have been modified for a clear and transparent sound. Based on the MOD of (K company), we have incorporated the original MOD. Basically, it is noiseless, and the added SW creates a thicker and more powerful distortion, allowing for distortion that takes advantage of picking nuances. ★ Clipping can be switched with the 3-WAY switch on the left side of the main unit. The switch down is the same silicon symmetrical mode as the normal version. It distorts and compresses the most among the 3 patterns, and is characterized by a clean and fine distortion. ★ The LED mode is activated with the switch up, resulting in a thick TUBE sound. The red LED (the part with the TONE letters) next to the left switch lights up depending on the strength of the picking. ★ The switch center allows you to select comp cut (booster mode) without compression and clipping diodes. ★ The SW on the right side of the main unit switches to a thicker sound (FAT mode), expanding the range of the TONE control. The impression of thinness characteristic of distortion is eliminated, with a focus on LOW to MID frequencies. ■■ Twin Drive Mode ■■ The foot switch added to the top of the main unit switches to the knobs on the side of the main unit. The left knob (GAIN2) and the right knob (LEVEL2) can be used to boost the sound during solos. It is possible to set different settings for backing and lead and switch instantly, making it practical. The ON-OFF check lamp is ultra-high brightness BLUE (blue) during normal operation, and the check lamp switches to ultra-high brightness RED (red) in BOOST mode. ★ Ultra-high brightness BLUE (blue) is used for the ON & OFF check lamp. Both 9V batteries and AC adapters are supported. ※ Since it is also listed on other sites, it may end early. Type... Electric Guitar Manufacturer... BOSS #DS1MOD #BOSS #40th #Modify