Mini 4WD MA Decross Completed Full Bearing 《Settings Changed》 Compatible with B-MAX Stock Class All Tamiya genuine parts 《Specs》 【Body】 ・Decross 01 (Painted) ・Primer, Matte Black Decal Flat Clear Coating ※Slight peeling on decals ※Slight peeling on canopy It peeled off without noticing during the manufacturing process. Repaired. 【Front】※Thrust is applied ・Main: 8-9mm 2-stage aluminum bearing rollers ・Under: AO 830 roller bearing ・Stabilizer: High Mount Tube Stabilizer ・Full Cowl Mini 4WD 30th Anniversary HG Carbon Front Stay (1.5mm/Silver) ・Cap Screw 25mm ・FRP Sub Plate ・Slim Mass Damper (Small) ・Cap Screw 25mm (for mass damper) ・FRP Multi Reinforcement Plate 【Side】 ・MA Chassis Side Damper Set (Plate only) ・Mass Damper 【Rear】 ・9mm Roller Bearing (Top and Bottom) ・Cap Screw 30mm ・HG Carbon Multi Wide Rear Stay (1.5mm) J-CUP2024 ・Super X Chassis FRP Multi Reinforcement Plate ・Ball Link Mass Damper 【Tires】 ・Low Friction Small Diameter Narrow Tires (24mm) & Carbon Reinforced Wheels (3-spoke) ・Wheel through-hole processing done ・Round hole ball bearings 【Motor】 ・Normal Motor 【Gears】 ・3.5:1 ・520 Bearing ・Fluorine-coated gear shaft 【Other】 ・Countersunk screw processing (where necessary) ・Ball link mass damper is set to prevent detachment It is made carefully and thoroughly, but There is no correct answer in Mini 4WD, and the machine that finishes is the winner. This is a modification I personally wanted to try, so please understand. If you wish, I can include a pre-run 34000 rpm Mach Dash motor, but it will be a used item, so it's just a service.