This is a tip-over prevention battery holder type pro-po stand for the FUTABA 10PX. This part is designed to improve stability when the transmitter is placed on it. It is made of ABS resin and manufactured with a 3D printer. It has a 10px engraving on the side of one side only, and a 10px print in white on the bottom. Since it replaces the cover, it has a simple and unobtrusive appearance. 【Condition】 ・New, unused 【Compatible Models】 ・FUTABA 10PX ※The transmitter body shown in the photo is not included. 【Features】 ・Tip-over prevention battery holder ・ABS material ・3D printed product, so there are layer lines (please check the photos) 【Notes】 ・Due to the nature of 3D printed products, there may be layer lines and individual differences on the surface. ・Please refrain from purchasing if you are concerned about the fine finish. ・Strength is inferior to manufacturer products. Please be careful. ・It may be difficult to install. Please understand. ・Gaps may occur during installation. Please check the photos. 【About the charging port】 This is a product with a battery port "with" on the side of the case. If you don't need a hole for the battery charging port, please use "FUTABA 10PX Tip-over Prevention Pro-po Stand Side Hole-less" which is also available. The price is the same whether it has a hole or not. Please note that there is no rubber cover like the original. ※Price revised. Instant purchase is OK. If you have any questions, please comment. Type...Radio control