Thank you for viewing. This product is a bracket (mounting mount) for mounting Switch Hub 2 on a wall using a power outlet. It was designed for use at home. By using general Panasonic Cosmo Series and TOSHIBA WDG5413 series outlets, it can be installed with just a Phillips screwdriver. It is especially recommended for those who do not want to make holes in their wallpaper. It is the thinnest design among the outlet-mounted mounts on the market and adheres closely to the wall. By using a commercially available single-port L-shaped USB power adapter, you can install the SwitchBot Hub 2 more neatly. Please note that installation has not been confirmed on anything other than the Cosmo Series Wide 21 vertical 2-gang type and the TOSHIBA WDG5413 vertical 2-gang type. Also, processing is required for outlets with grounding. (Can be cut with scissors) - Set contents: Cover (bracket), case ※ SwitchBot Hub body and L-shaped tap are not included. - Weight: Approximately 120g - Material: Biomass plastic ※Caution ・Because it is designed to be as thin as possible, it is necessary to push the wiring into the cover. It's a little difficult, but please forgive us, as it will look very neat when installed. ・This product is made by a 3D modeling machine. There is no problem in use, but it will not have the strength and finish of general injection-molded industrial products. Some unevenness and layer marks may occur. ・It softens at 60 degrees Celsius or higher. We do not recommend using it in direct sunlight or in places with high temperatures. ・Depending on the building's structure, the humidity near the outlet may be displayed as high. Holder Mount Mounting bracket Bracket