Type of equipment: Hatchback Z-shaped molding Compatible car manufacturers: General purpose, Toyota, Nissan, Honda, Subaru, Suzuki, Mitsubishi, Mazda, Daihatsu Length: 110 cm. Please be sure to check the length of your car before purchasing. Due to the low price, we are not considering discounts. Thank you for your understanding. This is a molding to prevent dirt on the inside of the rear hatchback door. It can be installed inconspicuously as it is applied from the inside. Installation is simply done by sticking it on with the double-sided tape already attached. If the adhesive strength is weak, please prepare your own. Example) The photo shows a Subaru Levorg vm, 100 cm was sufficient. *Please install it as shown in the 5th photo. Also, as a bonus, we will include 4 pieces of cut aluminum tape (without jagged edges). By applying the molding and aluminum tape, the inside of the back door will be less likely to get dirty. Yaris, Alphard, Esquire, Corolla, Fielder, Hiace, Sienta, Noah, Hilux, Harrier, Raize, Land Cruiser, Roomy, Vellfire, Voxy, c-hr, rav4 X-Trail, Elgrand, Kicks, Juke, Serena, Days, Note Odyssey, Step WGN, Fit, Freed, Vezel, n-box, n-one, n-van, n-wgn cx-3, cx-30, cx-4, cx-5, cx-7, cx-8, mazda2, mazda3, mx-30 Outlander, Eclipse Cross, Delica, ek Cross, ek Wagon Outback, Impreza G4, xv, Forester, Legacy B4, Levorg, BRZ, S4 Ignis, Escudo, Jimny, Sierra, Swift, Spacia, Solio, Hustler, Wagon R, SX4 CT, ES, GS, HS, IS, LC, LFA, LM, LS, LX, NX, RC, RX, SC, UX Tanto, Move, Canvas, Rocky, Taft, Thor, Wake