Thank you for your interest in our product. This product is a pedal riser for small pedals like TONEX and One Control. It is a very lightweight product, as pedal risers from major manufacturers weigh around 150-200g. We have created mounting parts to meet the following needs: * Don't want to stick Velcro directly to the bottom of the effector. * Want to neatly wire the DC cable to the effector. * Want to raise the height of the effector for placement at the rear of the board, etc. By attaching this product and the effector with silicone tape or easily removable double-sided tape, you can mount it on the effector board without making it sticky. 【Target Products】 Effectors that fit on the top plate (43mm * 93mm) of this product are対象. We have larger products available in separate listings, so please consider those for products with significantly different sizes. 【Specifications】 Size: Top plate 43mm * 93mm, Total height 18mm Weight: Approximately 20g Inner diameter: Cable routing up to 12mm in diameter 【Material】 Made of PLA (black) Although we check the products, Due to the nature of 3D printers, burrs, layer lines, stringing, and support material marks may remain slightly. Please understand. 【Other】 Please purchase after you are satisfied to avoid any problems after purchase. You can purchase immediately without any inquiries. Thank you for your consideration. #guitar #bass #effector #pedalriser #effectorbasetable #compacteffector