(JP¥2,300)
+HK$94.96 Shipping fee
+HK$15.55 Agent service fee
Text are automatically translated.
Report translation issueText are automatically translated.
Report translation issueFraud prevention
Customer support
Refund support for customers
Seller info
Forma P
5/5306
View detail
Item condition
Brand New
Ships from
Japan
Category
Something went wrong, please try again later.
This item can't be bundled due to shipping restrictions. Please buy separately.
Something went wrong, please try again later.
This item can't be bundled due to shipping restrictions. Please buy separately.
DAWNFIELD PRODUCTS We are pleased to announce that we have switched from the Jimny JB23 to the Jimny Nomad JC74. We have started developing original 3D-printed parts and items, utilizing our professional product design and engineering skills. ◎ Designed to meet safety standards ◎ Uses 35mm screws, reinforced ball joint design This is a 3D-printed short stay for those who feel that the position of the genuine room mirror in the Jimny Nomad JC74 is "a little low." It moves the mirror position approximately 32mm higher than the original, helping to improve visibility. ■ Safety In the event of a collision, the design allows the stay to detach along with the mirror, just like the original. The design is safety-conscious and complies with safety standards. ■ Installation Use by replacing the original stay. When installing, remove the transparent parts attached to the original stay and attach them to this product before screwing it to the vehicle. ■ Tools Required ・Interior panel remover (can be done by hand if you don't have one) ・Phillips screwdriver (#2) ■ Product Specifications ・Designed specifically for the Jimny Nomad JC74 ・Measured and designed by removing the genuine stay from a new car ・Reinforced ball joint shaft (using 35mm screws) ・Designed to meet safety standards (designed to reuse and adapt genuine parts) ・3D printed (using ABS filament: heat resistant ◎ approx. 85℃) ・Color: Gray (※Black is also available upon request.) ■ Caution The inside of a car gets very hot in the summer. We do not recommend interior parts made of PLA filament because they may deform. This product is made of heat-resistant (heat resistance approx. 85℃) ABS resin. 【Product Management Number】 DFP-JN-ST-GR-V1-007 【Search Keywords】 #Jimny #JimnyNomad #JB74 #JimnyCustom #JimnyInteriorCustom #JimnyParts #RoomMirror #VisibilityImprovement #InteriorCustom #3DPrinter #3DPrintedParts #ABSResin #dawnfieldproducts
1 week ago