※ - Please note that this item is made to order, so it may take some time to ship. ※ - Discounts are not available except for bulk purchases. This is a ring to be placed under the platter of the KORG handytraxx play to reduce needle skipping. It comes with about 3 washers of 0.1mm each to adjust the height. It can be made from either PLA (plastic) or TPU (rubber-like) material. PLA has good slip, but there is a slight clicking sound when it hits. TPU has less clicking sound, but the slip is slightly worse. The finish is cleaner with PLA. TPU may be more expensive because it takes longer to make and the finish may be poor. If no specification is given, we will ship the PLA black as shown in the first image. _______________________________ Please specify the following in the comment section before or after your order: Color: Material: PLA or TPU Available colors (PLA): Black, Red, Blue, Green, Yellow, White, Natural Wood, Dark Wood, Pink Available colors (PLA): _______________________________ This is a 3D printed output. Material: PLA Layer pitch: 0.2mm Nozzle diameter: 0.4mm _______________________________ This product reduces the cut lag of the KORG handytraxx play to the extreme, and by using TPU, a rubber-like material, the clicking sound when it hits is reduced. If the sound is not cut, please cut it slightly with a cutter, etc. This product is a 3D printed output. Please note that layer lines and burrs may appear depending on the individual. All designs are original design data. Search terms faderlab friskfader pt01 handytrax portablist handytraxx