I have uploaded a video on YouTube, so please search for "Pre-Clip Stick 3D Printer" and take a look. There are two ways to use it: ① Attach a nunchaku with a rope. As shown in photos 3 and 4, hook it with the carabiner gate open, and pull it diagonally downwards to close the gate. ② Attach the rope to the already attached nunchaku. As shown in photos 1 and 2, with the rope wrapped around the gate, pull one side of the rope to open the gate and attach it. [Tips for Use] ・When lifting, the rope may slip due to its weight, so hold the rope (both sides) together with the stick. ・When attaching to the gate, hold one side of the rope with the stick and pull the other rope with your other hand. This product is the type that can be attached to the tip of a Pamo brush. (I also sell a type that can be attached to a selfie stick separately) Both wire gates and key lock gates can be used. ※ Only the pre-clip attachment in photos 5 and 6 is included; nunchaku and sticks are not included. It can be used without problems if the gate width is about 11-12mm, but I can also make it to fit other sizes if you wish. Since it is made with a 3D printer, please forgive any burrs that do not affect the function. Free climbing, alpine climbing, Petzl, Black Diamond, Metolius, quickdraw, draw, clip stick, quickdraw, cam, gear