Compatible Vehicle Manufacturers: Toyota, specifically for the new Sienta! Type of Parts: Both side molding emblems & rear & front emblems Material: Acrylic resin Base: Glossy white Surface: Hairline sheet applied This is a side molding accessory specifically for the Toyota new Sienta. It is a self-made product using laser processing. It's a dress-up part that is installed on the recessed area of the Sienta logo on the side molding of the new Sienta using strong double-sided tape. There are many aftermarket products with Roman alphabet logos, but most of them are just stickers... This product uses acrylic resin, so you don't have to worry about air bubbles getting trapped underneath like with stickers! Page 3 of the images shows an actual installation. Note: The installation image is a different color than the product being sold! Installation method: Strong double-sided tape is applied to the back of the Roman alphabet plate. Installation is easy, just fit it into the logo area under the side molding of the car body. Before installation, it is important to thoroughly wipe off any dirt from the installation area! On my own car, I've had it installed since February 2023, and I haven't had any problems such as it falling off or being damaged! This is a self-made product, so please understand this before purchasing. There may be some blackening, hazing, or slight unevenness at the cut-out points of the letters due to laser processing! Please refrain from purchasing if you are sensitive to these details. I do not accept price negotiations for this product! m(__)m Also, I am not responsible for any damage to your car caused by the installation of this product. m(_ _)m