Handmade item made with a 3D printer. Wakasagi fishing bait box Size: Approximately 80mm (length) x 140mm (width) x 54mm (height) Mesh size: 1.5mm x 1.5mm A more compact type, slightly smaller, has been created, eliminating the need for magnets. The mesh has been changed from a separate type to an integrated type, with the mesh depth increased to 22mm, and the upper lip of the mesh has also been enlarged. By removing the plate, shaking to remove sawdust, and then inserting the plate, you can prevent the bait from slipping through to the sawdust side. A slip-through prevention plate has been installed, and the mesh size has been increased to 1.5mm x 1.5mm to make it easier to remove sawdust. Magnets and non-slip silicone are attached to the bottom of the box. The magnet height is slightly lower, providing a secure grip during normal use. The magnets are designed to be compatible with a table that will be made in the future. It can also be used with tables that have magnetic properties. It holds firmly and is easy to use. Please note that since this is made with a 3D printer, there may be lines, burrs, unevenness, and minor scratches due to filament breaks. PLA plus material is used, which has a higher heat resistance than usual, but warping may occur at temperatures above 60 degrees Celsius, so please be careful in hot weather such as under the summer sun. This is a handmade item, so although it is unused, it is considered to be without any noticeable scratches or stains. We check the item before shipping, but if there are any scratches or malfunctions, we will exchange it (^^) Please contact us before leaving a review (^^) Nowadays, two electric wakasagi reels are the mainstream, and it's fun to catch a lot of fish. The hinge color will be silver or gold.