⚠️ Important Notes ⚠️ 1. The MS-50G+ unit shown in the images is not included in the package. 2. Due to the nature of 3D printing, there may be dimensional errors, variations in design, burrs, layer lines, stringing, and support material residue. 3. Please do not apply excessive force to the product, as it may cause damage or injury. ---------------------------------- Product Description: This is a scroll plate & footswitch hat set for the following ZOOM products: * MULTISTOMP MS-50G+ * MULTISTOMP MS-60B+ * MULTISTOMP MS-70CDR+ * MULTISTOMP MS-200D+ Based on customer feedback, the footswitch hat has been changed to be 5mm thicker than the previous version (see image 8, the footswitch hat on the left). We created this using a 3D printer because we wanted to make the unit's cursor keys and footswitches easier to press. As shown in image 1, the arrow parts are made of a glow-in-the-dark material. It glows after being exposed to strong light, but the glow doesn't last very long, so please consider it a bonus. ---------------------------------- Installation Instructions: 1. Attach the footswitch hat to the unit's footswitch. 2. Refer to image 6 and apply the included acrylic double-sided tape to the four cursor keys on the unit. 3. Remove the film from the top of the acrylic double-sided tape (it may be a little difficult to peel off, please understand), and then attach the left and right scroll plates, balancing them (see image 2). Note: The acrylic double-sided tape is designed to peel off cleanly without leaving adhesive residue. ---------------------------------- Contents: * 【Footswitch Hat】 x 1 (Silk Silver) * 【Cursor Key Buttons】 Left and Right, x 1 each * 【Acrylic Double-Sided Tape (4 pieces)】 x 1 (See image 7) Scroll Plate and Footswitch Hat Material: 3D printer filament (PLA+)