Brand new, unused. Cable length: 38.5cm (excluding white parts and pins) This is a modified header pin-type lever harness, allowing connection to buttons. It can be used to create the lever setup that Mr. Haitani tweeted about, which became a hot topic. Mr. Eita also uses a jump button for fast commands. Recently, Mr. Mago and Mr. Fuudo have also ordered jump buttons. This is a custom that could become mainstream in the pro scene. Connects to the jump button as shown in the photo. *Assumes the button has GND wiring. *For Raspberry Pi GP2040 boards. You can disable the up direction on the lever and set jump to a button. ★ General Advantages When switching from crouching guard to standing guard after seeing a mid-attack, pressing the jump button while the lever is still in place will result in a standing guard. By inputting the Hadoken command up to the diagonal and then pressing the jump button, the input becomes horizontal, making the input faster (according to Mr. Mago, it comes out in 9 frames). Shoryuken also becomes faster (according to Mr. Eita and Mr. Mago). ★ Chun-Li's Advantages [Hold down input → Press and release jump button → K button] Allows for a fast Tenshokyaku. [Down input] ↓ [Simultaneous input of jump button and down input] N [Releasing the jump button results in only down input] ↓ This is how it works. In addition to the advantage of being able to perform N↓N↓ inputs like a leverless controller, it also prevents lever flicking and accidental jump activation. #RealArcade #HORI #RAP #HAYABUSA #隼 #ArcadeStick #Lever #Custom #Cable #Harness #RaspberryPi #Brook