This is a set including a smartphone holder from Daiso. Since there isn't a good place to mount a smartphone holder in an Every, I created a mount using a 3D printer. I fixed the spherical part taken from the Daiso smartphone holder to this mount, and then attached a separate smartphone holder with the spherical part removed. The spherical part in the first photo is the part taken from the Daiso holder. Features: Doesn't block the air conditioning vents. Two mounting points on the mount (top and bottom). Smartphone doesn't overlap with the steering wheel. Drink holder can be used. Small item tray can be used (to some extent). Doesn't touch the turn signal when operating. Product Contents: Mount: 1 piece, made of ABS Daiso Smartphone Holder: JAN code: 4562380812766 (Unopened) Items Needed Besides the Product: Smartphone holder you want to use for mounting Double-sided tape, 0.8mm thick About Installation: The Daiso holder is covered in rubber, but it's easy to cut off with nippers. The tapping screws on the spherical part are short, so if you're worried about securing it to the mount, consider using adhesive as well. The mount may peel off if only attached to the wall part, so be sure to apply double-sided tape to the U-shaped part as well. Please be careful not to get injured when disassembling the Daiso holder. Regarding Using a Different Smartphone Holder: The spherical part of the Daiso holder was approximately 17mm in diameter. I saw in an online article that the size of this part is generally the same for all holders, but please make your own judgment. Notes: Since it's made with a layered 3D printer, there are layer lines and scratches. There is no guarantee if the combination of the mount, Daiso holder, and the holder you use doesn't work correctly. The packaging is not elaborate, only enough to prevent the corners of the product from damaging the envelope, and the packaging materials are reused. There is no warranty for this product, nor is there any warranty for problems caused by using the product. Thank you.