A dual-track power pack has been completed. Size: 290mm x 210mm x 105mm x 60mm Due to being handmade, there are a few scratches and holes from processing errors, but they are not very noticeable. The base control circuit uses the proven Kato model, and an analog voltmeter & ammeter have been installed. The output has been increased to 12W. If overloaded, the safety device will activate and cut off the current. To reset, press the red button on the back (right side of photo 7). Photos 8, 9, and 10 show the circuit components. Please note that there are some uneven spots in the application of the control panel (sticker). You can't see it in the photos! (You can see it depending on the direction of the light.) The power supply capacity is, of course, dual-track, so simultaneous running is possible. The speed can also be adjusted individually. The maximum voltage is adjusted (set) to 13V under no load. N gauge and HO gauge trains can be run. In addition, a fan has been installed to suppress temperature rise. Operate it with the switch (photo 4). There are scratches from processing. Photo 13 (below the AC input terminal) The voltage is set to 13V under no load. A power output that supports options has also been installed. Capacity is DC12V-2A. A Kato-spec connector and a connector for connecting point switches, etc., are included as accessories (photo 14). The hole in photo 11 is a ventilation hole. The transparent protective seal on the bottom (black) has not been removed, so please remove it yourself. The price is based on the cost of materials only, so please understand. Type...Other Material...Resin/Resin Type...Miniature Drink Material...Wool Felt