This is a set of two self-made rails that allow you to connect Plarail to wooden rails such as BRIO. You can play with them connected as shown in the photos. ① Confirmed that it can be connected with your existing Plarail and wooden rails. ② Compatible with other brands of wooden rails such as IKEA's LILLABO and Toys"R"Us's imaginarium! ③ The length of the rail is approximately 5 cm. ④ The slope has steps to increase friction. ⑤ The material is PLA, a plant-based resin used in commercially available toys. ⑥ It is a matte brown color, so it is not very noticeable when placed next to wooden rails. ※ Since it is not a material mixed with wood powder, there is no need to worry about powder coming out during use. ⑦ The difference in height and rail width between Plarail and wooden rails is absorbed by the slope of the conversion rail, allowing for smooth running. 【Caution】 The back of the parts is flat, so some parts that use the recesses on the back, such as Plarail bridge piers and railroad crossing parts, cannot be combined. Only 4 self-made rails will be sent. Other parts and rails shown in the photos are not included. This is a 3D printed product. We try to print as cleanly as possible, but there may be individual differences such as layer lines and scratches. Please purchase only if you understand this. We also make other conversion rails, so please take a look if you like. #PussyCat's Conversion Rails #Plarail #BRIO #brio #Brio #lillabo #LILLABO #Lillabo #imaginarium #Imaginarium #KIDEA #MICKI #WoodenRail #Conversion #3DPrinter Vehicle type...Other Type...Tracks Rail gauge...Other