Compatible car manufacturers: Toyota, specifically for the new Sienta! Type of accessories: Both side & rear & front emblems Material: Acrylic resin, light gray matte sienta For the new Toyota Sienta, this is for both side moldings, rear, and front. This is a self-made product using laser processing. It's a dress-up part that attaches to the recessed area of the Sienta logo on the side moldings of the new Sienta using strong double-sided tape. There are many aftermarket products with Roman letter logos, but most of them are just stickers... This product uses acrylic resin, so you don't have to worry about air bubbles getting trapped underneath like with stickers! Page 3 shows an actual installation image. Note: The installation image is a different color than the product being sold! Installation method: Strong double-sided tape is applied to the back of the Roman letter plates. Simply insert it into the logo area under the side moldings of the car for easy installation. It is important to thoroughly wipe off any dirt from the installation area before installation! On my own car, I've had no problems such as detachment or damage since installation in February 2023! This is a self-made product, so please understand this before purchasing. There may be some blackening on the edges due to laser processing, and slight unevenness in the cut-out areas of the letters. Please refrain from purchasing if you are concerned about these details. Negotiations for price reduction are not accepted for this product! m(__)m Also, we are not responsible for any damage to your car caused by the installation of this product. m(_ _)m