Thank you for viewing. Defi Turbo Meter Old Model Black Panel White Illumination Link Unit with Wiring Both the meter body and link unit have minor scratches. (Defect) Of the connector pins inside the sensor cable connector, the pins for the red and white wires are loose and will come out if pulled. Because there is a risk that only the pins will come out without being inserted when the connector is inserted into the meter, the base of the connector has been fixed with hot melt. There is no problem if it is inserted firmly, so please insert it with care. The cable sheath was torn in one place, so it has been protected with vinyl tape as a precaution. There was no damage to the wires inside the sheath. The silicone hose to be inserted into the sensor part is not included. Hose bands are also not included. There are traces of one-touch connectors on the + constant connection wire and the accessory connection wire of the power harness. The ground is a makeshift finish, so it should be fine as is, but please consider remaking it if possible. There are silicone or bond-like substances, likely applied by the previous owner, on the female connector of the link unit. It is thought that this was done to prevent the connector from coming off. There should be no problem with use. The Velcro is as is. The outside of the meter holder has a matte, fine textured pattern, but there is a section on the left half that is glossy. Also, the gap between the meter holder and the meter body is quite loose, so wrapping a 1-2mm gap tape around the circumference of the meter may help it fit. Other than the above, there are no other concerns. - Model: Turbo Meter - Accessories: Complete wiring set, Link Unit - Color: Black/Silver - Condition: Minor scratches Thank you for your consideration.