【※Plate not included.】 This is an assembly for a Jazz Bass. Recommended for those who want to upgrade their current bass! Assembly Introduction 【Pots】 Entry-level bass guitars often have metric-sized holes in their plates. I considered CTS pots, which are famous for their quality, but CTS pots are inch-sized and not compatible. Therefore, I chose Alpha pots, which are metric-sized and of good quality. They are 250kΩ, a good value for bass guitars. You can install them directly onto your existing plate. This time, I made them with full-size pots. 【Jack】 I use a Japanese-made jack. The quality is quite good, and I feel it's not much different from Switchcraft. 【Wiring】 The wiring uses cross-wire, which is also used in Fender and other high-end guitars. It's quite stiff and durable. ※The cross-wire will be either skin-colored or yellow. I usually use skin-colored wire, but sometimes it will be yellow. Please note that there is no change in functionality. 【Capacitor】 I chose the classic Orange Drop capacitor. Specs → 200V 0.047uf It gives a clear sound even when the tone is adjusted, without sounding muddy. As described above, I have put a lot of care into the quality. All parts are new. I have grounded all the pots to reduce noise, so there is very little noise. Please feel free to upgrade. Please refer to photos 3 and 4 for pickup wiring and pot dimensions. Power-on tested. Shipping will be via Yu-Yu Mercari Mail A4 size brown envelope. If you are worried about wire breakage, I can send it via Yu-Yu Mercari Mail Yu-Packet Plus for an additional 200 yen. I have already kept the price as low as possible, so I cannot offer any further discounts. #Bass