Iba Works roof carrier. Used on a second-generation Mitsubishi Pajero. Dimensions are approximately 170cm x 132cm. It attaches directly to the rails as shown in the fifth photo. The first photo is an installation example. Everything except the carrier is not included. The front is a flowing type, which is rare. The width can be adjusted to fit the roof rails, so it can be installed on vehicles other than the Pajero. (I think it can also be installed on older Land Cruisers, etc.) All parts are included, but some screws are rusty, although they can still be used if replaced with ones from a home center, etc. (Used until October 2025.) Since it is large, pickup is recommended, but please consult if that is difficult. Shipping is possible, but it will take some time. Marks are also attached, so you can install them by matching them. I am in Hiroshima Prefecture, but I can go out to a certain extent, so please consult. I can help with the installation.