Easy 1x4 Adjuster Finished Product DIY Storage Parts Set of 4, Anonymous Delivery, with Scratch Prevention Sheet For other quantities, please comment. These are DIY parts for fixing 1x4 lumber to the top and bottom to create a pillar. You don't need complicated steps or special tools just to set up a pillar. You can easily install them because they are firmly fixed using the force of a jack. Imitation and plagiarism are prohibited. The structure is different from plagiarized products. Plagiarized products do not have the bolts fixed, so they lack strength. The upper part has fixed bolts, so it is stronger than plagiarized products. It is fixed in a special way and cannot be removed. Installation Method ① Cut the 1x4 to be the pillar at a height of approximately 80mm less than the installation location (measure the shortest adjuster as there are slight individual errors). ② Screw the lower part of the adjuster to the top of the 1x4 cut in ①. (Photo. 4) ※It is easier to insert if you use the lower hole as a drill guide and pre-drill a hole in the pillar. Since it is thin with 1x4, pre-drilling a hole will also prevent cracking. ③ Insert the screw side of the upper part of the adjuster into the hole in the pillar made in ②. ④ Once positioned in the installation location, stand it vertically (level), and tighten by turning the lower nut clockwise with a wrench. Tools Required 〇 13mm wrench or monkey wrench, etc., a tool that can turn the nut 〇 Electric drill or impact driver or Phillips screwdriver 〇 Saw (can be cut at a home center) 〇 Level (there are also apps.) Drill not required Due to being handmade, there may be some variations. Assembly is just screwing, the same as commercially available adjusters. It's a finished product, so just screw it in. Since it's 1x4, it will bend when tightened if you make a long pillar, so if you want a long pillar, 2x4 is better. For other quantities, please comment. #TwoByFour #OneByFour #WindowFrameShelf #KitchenShelf #Adjuster