※ This product is only the tilt stand. ※ Anonymous delivery Made with a 3D printer. Tilt stand for trackball mouse logocool ERGO M575. The tilt angle is set to 30°. Using the tilt stand allows you to fix your wrist at a more natural angle. This allows for operation with a relaxed arm posture, reducing the strain on your wrist. The color and texture are close to the original, without compromising the design of the trackball mouse itself. Five non-slip pads are attached to the back of the stand, allowing for stable use. You can operate the power switch with the stand attached. It is fixed in two places: the ball hole and the cover groove. The USB receiver and battery cover can be stored inside the stand. Color: Black Material (body) PLA, (non-slip) High-performance urethane foam 《Notes》 ・Trackball mouse body is not included. ・Please refrain from using in high-temperature environments. (Heat resistance: approx. 60℃) ・3D printed products may have fine horizontal and vertical stripes, and stringing. ・Color may adhere from the non-slip pads to the contact surface, such as plywood flooring and vinyl flooring. ・Do not use for purposes other than the original intended use. ・Do not engage in actions that may cause damage or rough handling. ・Do not use damaged or deformed products as they are. ・We inspect the products before shipping, but please contact us if there are any defects. We will respond as much as possible. ≪Installation Method≫ 1. Store the USB receiver in the stand. 2. Store the battery cover. 3. Hook the fixing claws onto the cover groove of the mouse body, and then insert the fixing protrusions into the ball hole.