Mini 4WD Brake Sponge Processing Tool x 1 This is a single item for sale. * Image ⑥ will be shipped. * Price may change depending on the cost of materials. * LEGO minifigures are not included. * Shipped via Yu-Packet Mini. * We will check the operation and make a final check of screws, nuts, etc. just before shipping. Thank you for your understanding. - 2 AA batteries (not included) - Switch: ON/OFF switch [Can be processed in 2-3 seconds] - Angle adjustable up to approximately 30 degrees - Heating wire width: approximately 43mm - 1 test 3mm white brake (included) - Spare heating wire, a little over 1m (included) - Dedicated case (included) We have tested it several times to confirm its operation, so it is listed as "Like New". - We have deliberately not soldered the wiring for easy maintenance. It will be packed in a dedicated case and shipped via Yu-Packet Mini. * Please read and note * When using, the heating wire temperature rises and there is a risk of burns, so please be sure to wear protective gloves when working. Also, when the heating wire is applied to the brake sponge, the brake sponge will melt and produce a foul-smelling smoke, so please be sure to wear a mask and work in a well-ventilated area. Please understand that returns and refunds are not possible for breakdowns or damage due to amateur workmanship. Therefore, please only purchase if you are able to perform a certain amount of Mini 4WD processing. If you are nervous or looking for perfection, please refrain from purchasing. Thank you for your understanding and purchase. Thank you for viewing.