This is an original carbide triangular scraper from our workshop. The length before sharpening is 30mm. There are two types: the right one in photo 1 has a shaft diameter of φ2 (actual measurement approx. 2.4mm), and the left one is φ1.5 (actual measurement approx. 1.9mm). This is a single item listing. Please determine which one it is from the title. Image 2 uses φ2, please understand that it is a rough guide for the length. Unlike the standard basic scraper with a house-shaped blade cross-section, this has a triangular pyramid cross-section with a 60-degree angle, so there are three cutting edges. It can be said to be an inexpensive scraper tip. The mirror finish provides excellent edge retention and sharpness. It is a versatile tool for chamfering and deburring plastics, modeling wax, urethane coatings, and soft materials to precious metals. Engraving scrapers are mainly used for polishing work, such as scraping off precious metals, but since it is a versatile tool, I prototyped it for my own use in repairing urethane coatings on fishing tackle. Made from the highest quality domestic carbide material, and I sharpen it myself, so of course, it is a purely domestic product. Please be aware that Chinese products are significantly inferior in terms of carbide material, as well as workmanship. Notes: φ1.5 has a thin diameter, and the taper is much sharper than φ2 to ensure the length of the blade, so it is not suitable for use on hard materials such as metal. The shaft has individual differences due to the diameter and the black skin color. The length may be shortened by about 28mm due to sharpening. The tip is pointed, so it will chip easily if you bump it. However, the tip is not as sharp as a marking tool because it has multiple vertices. φ2 is close to the router shaft diameter, but it is not a scraper to be used in a router or to use the tip. Please use it with sufficient caution, including injury, such as using protective glasses. This is a listing for the scraper tip with the cutting edge only (cap included). The items in the photos are not included, they are mainly for illustrative purposes. Please note that there may be slight differences from the actual product due to the use of images. Please use a pin vise or other methods to create your own grip. φ2 is a little thick for a 2mm core holder, but it may be usable depending on the object. Initial defects are covered, but blade chipping or damage after use is not eligible for replacement. Angle adjustments are also possible during re-sharpening, and we will accept requests separately after purchase. Delivery will be via Mercari's Nekopos service, including shipping. Workshop BijoDam http://bijodam.com/ Graduated from the Jewelry Craft Engraving and Carving Department, CGL DC, Yutaka Ota