1x4 Adjuster Finished Product DIY Storage Parts Set of 6, Anonymous Delivery Other quantities, with anti-scratch sheets, are 100 yen extra. Please comment. These are DIY parts for fixing 1x4 lumber to create pillars. You don't need complicated procedures or special tools just to set up the pillars. You can easily install them because they can be firmly fixed using the force of a jack. Imitation and plagiarism are prohibited. The structure is different from plagiarized products. Plagiarized products do not have fixed bolts, so they lack strength. The upper part has fixed bolts, so it has more strength than plagiarized products. It is fixed in a special way and cannot be removed. Installation Method ① Cut the 1x4 lumber that will become the pillar to a height of approximately 80mm less than the installation location (there may be slight individual differences, so measure the shortest adjuster). ② Screw the lower part of the adjuster to the top of the 1x4 cut in ①. (Photo 4) ※ It is easier to insert if you use the lower hole as a drill guide and pre-drill a hole in the pillar. Since 1x4 is thin, pre-drilling a hole will also prevent cracking. ③ Insert the screw side of the upper part of the adjuster into the hole in the pillar made in ②. ④ Once positioned in the installation location, stand it vertically (use a level), and tighten the lower nut clockwise with a wrench to tighten it. Tools Required 〇 13mm wrench or monkey wrench, etc., a tool to turn the nut 〇 Electric drill or impact driver or Phillips screwdriver 〇 Saw (can be cut at a home center) 〇 Level (there are also apps.) Drill not required Due to being handmade, there may be some variations. Assembly is just screwing, the same as commercially available adjusters. It's a finished product, so just screw it in. Since it's 1x4, it will bend when tightened if you make a long, thin pillar, so if you want a longer pillar, 2x4 is better. Please comment for other quantities. #twobyfour #onebyfour #windowframeshelf #kitchenshelf #adjuster #tensionwallstorage