Repronizer 3D Plus (Bio-Programming) Purchased in the fall of 2018 from an authorized online retailer for approximately 40,000 yen. I didn't use it much because I had multiple hair dryers. I used it 2-3 times a week for 3 years. After that, it was stored in a drawer. The set nozzle is unused and unopened. For the listing, I tested its operation by running hot and cold air for about 15 minutes. I didn't find any parts of the cord or power supply getting particularly hot, and there was no strange smell, so I think it can still be used normally. I've included as many pictures as possible of the filter and the inside, so please take a look. I don't think there's any dust accumulation or damage that would interfere with use (in my amateur opinion). The black scuff on the round part is a bit noticeable (image 7). I would appreciate it if you could purchase it understanding that it is a used item and has been stored at home. Contents: Nozzle (1) Product Name: Repronizer 3D Plus Model Number: REP3D-G-JP Power Supply: AC 100V 50/60Hz Power Consumption: 1200W (AC100V) Hot Air Temperature: Approximately 110°C (at an ambient temperature of 30°C) Size: Height 228.9 x Width 233.5 x Depth 103.8mm (excluding nozzle) Weight: Approximately 722g (excluding nozzle) Safety Device: Overheat protection device (thermostat, thermal fuse) Power Cord Length: 2.6m Please be sure to check any questions you may have via comments before purchasing, and please refrain from cancellations or complaints after purchase. Shipping costs can be discounted for combined purchases. Even if comments are being made, I will prioritize transactions with those who purchase immediately. I may delete the listing without notice as I am also listing on other sites. Recycled materials may be used for packing materials when shipping. I disinfect my hands and materials when packing.