Thank you for viewing! Feel free to ask any questions in the comments. Negotiations for price reductions are not accepted. Thank you for your understanding. This smartphone holder is compatible with phones up to 18mm thick. The image shows an iPhone XR with an iFace case and a smartphone ring attached. (iPhone 15 and 16 also worked without issue.) It can be used while charging in either portrait or landscape orientation. This smartphone holder uses a rail-slide system to support both portrait and landscape orientations, which inevitably causes wear on the holder itself. Therefore, we sell replacement holder parts separately, so please be aware of this. 1. Rail + Holder (Basic Set) 1900 yen 2. Basic Set + 1 Spare Holder 2200 yen 3. Spare Holder Only 500 yen When purchasing the 2. Spare Holder Set, it is 200 yen cheaper than purchasing 3. individually. Please note that this is the page for option 1. ABS resin is used, and there are no issues with deformation even in a car in the summer heat. This product is made with a 3D printer. There may be layer lines or some unevenness, but this does not affect use. ⭐︎Color⭐︎ Black (Material: ABS resin) Heat resistance is approximately 80°C. ⭐︎Dimensions⭐︎ Internal dimensions: Max width approx. 164mm, depth approx. 18mm ⭐︎Shipping Method⭐︎ Wrapped in bubble wrap and shipped via Yu-Packet Post Mini. To prevent damage during shipping, the rail and holder parts will be separated and wrapped. Please assemble them yourself upon receipt. If the order falls on a weekend, shipping may be delayed until the following week. #3Dprinter #DelicaMini #Mitsubishi #SmartphoneHolder #SmartphoneStand