Paul Reed Smith
(JP¥8,480)
+HK$739.62 Shipping fee
+HK$15.74 Agent service fee
Text are automatically translated.
Report translation issueText are automatically translated.
Report translation issueFraud prevention
Customer support
Refund support for customers
Seller info
M.W.Works
5/52580
View detail
Item condition
Brand New
Brand
Paul Reed Smith
Ships from
Japan
Category
Something went wrong, please try again later.
This item can't be bundled due to shipping restrictions. Please buy separately.
Something went wrong, please try again later.
This item can't be bundled due to shipping restrictions. Please buy separately.
This item has been treated to improve weather resistance and strength. It is pre-painted and basically maintenance-free. It's difficult to reproduce in photos, but it uses impregnation dye, and the actual item shimmers like silk. The wood grain appears strongly, especially when illuminated in a dark place (see the second image). It aims for the texture of Hawaiian Koa, but it has resulted in something else exotic. Partial impregnation inhibition is applied, creating a complex pattern. We hope you will enjoy it by holding it in your hand. ======== Specifications and Details ======== This is an escutcheon ring designed with PRS's Paul's type as a motif. ※ It is not a compatible part with Paul's type, and the hole positions are the same universal standard as Cusuton24 and many other manufacturers. It should be possible to replace it with most manufacturers as long as there is no part interference. The last photo is of a different work, but it is an image of the same type of product installed. Thickness is approximately 4.5mm. The four corner fixing screws support a head diameter of 4mm / shaft diameter of 2.8mm, and the coil mount screws support a head diameter of 5.2mm / shaft diameter of 3mm. The inner diameter is just right for Duncan's metal cover type, and it has a smaller gap than a typical escutcheon ring, giving it a stylish look. === Notes === If you install it as is, it will be the standard height, but if you want to lower the pickup height from the default, please try the PRS extension mount screws that we sell separately. The original screws are cut too short, and commercially available ones are too long and will interfere with the bottom of the recess. Also, the screw holes on the guitar body side seem to be done by hand, and tend to be rough, and the screw holes are often slanted, or the escutcheon is installed distorted. There are also cases where the escutcheon side has been forcibly installed by drilling. We have designed the hole diameter with some leeway, but please do not force it if you feel any discomfort to avoid damage. You can tighten it beautifully by temporarily securing the four screws by tracing the spiral marks and tightening each one a little at a time. Also, USA-made PRS springs are long and too strong, so we recommend purchasing appropriate ones or cutting them to some extent before installing them.
1 week ago