☀️ We are looking for advantageous [bulk purchase applications] ☀️ ⚠️ This carbon unit is a custom part for 【intermediate to advanced users】 who are somewhat familiar with Mini 4WD setups ⚠️ ✅ Features of the 1-axis rear anchor It mainly works to counter lane changes. By providing a range of motion that moves up and down, it prevents the machine from going out of the course due to bouncing back if it jumps higher than the course fence. By holding down the chassis side at two points and the rear cover part, unnecessary lateral movement is reduced. Also, the return (recovery) is easy to operate, so the accuracy is high. The shaft part uses a combination of Tarlbane and brass spacers to achieve smooth movement. ◉ 1-axis rear anchor / 19mm roller compatible recipe ・MA chassis / gray (ABS) ×1 ・Rear brake stay / J-CUP2023 ×2 ・Rear wide stay / J-CUP2024 ×2 ・Straight carbon ×3 ・Cap screw / 2×20.3mm ×1 ◉ Roller under guard ・Rear brake stay / J-CUP2023 ×2 ・Aluminum spacer / 3mm ×4 【Dangan-yo Tarlbane (2 types included)】 ◾️ 1-axis part: Hard / Silver ×1 【Replacement】 ◾️ Soft / Black ×2 ⚫︎ Weight of the rear unit: Approximately 14.1g 【Additional options】 ① Rear skid roller / 830 bearing 4,998 yen ② Chassis weight reduction + low center of gravity processing 2,998 yen ③ MA chassis A parts set 598 yen ✅ Changing to a reinforced type (PC + ABS) chassis, etc. Other requests are also accepted from the 【comment section】 ^ ^ ↓↓ If you like, please also take a look at what else is on sale ↓↓ #QUAD・STARS / Click here for a list of MA chassis products #QUAD・STARS / Click here for a list of carbon products ↑↑ Tap to jump to an easy-to-see page with only Mini 4WD ↑↑ 【Information】 ⚫︎ We only handle genuine Tamiya parts, so you can use them with confidence in official races. ⚫︎ Parts other than the carbon unit and chassis are sold separately m(_ _)m