SwitchBot Finger Robot Mount Base for Wall Light Switches ◆ Product Overview This is a mount base exclusively for the SwitchBot Finger Robot, compatible with Panasonic Cosmo Series Wide 21 (120 x 70mm). It can be installed on a single-row switch (1-gang) or the center switch of a three-gang vertical switch. ☆☆Caution☆☆ This product is designed based on the switch plates of Panasonic "Cosmo Series Wide 21". It is NOT compatible with square types (see photo), so please be careful not to make a mistake when purchasing. ◆ Product Contents (May be shipped assembled) Base x 1 Mount x 1 ※ SwitchBot unit is not included. ◆ Material PLA resin (white) Environmentally friendly material derived from plants. ※ Please use indoors as it is weak against high temperatures (40 degrees Celsius or higher). ◆ Installation Method 1. Combine and join the base and the mount part. (The parts are designed to fit together.) 2. Attach the SwitchBot unit to the mount part. 3. Fit the base into the switch plate. ※ It is designed to be a slightly tight fit for secure fixation. 【Important Notes】 ・ All products are shipped after operation check. During operation, the part that fixes the SwitchBot may move slightly, but this is a design specification. If there is a problem with the operation, please contact us via comment before evaluation. We will respond quickly and sincerely. ・ Due to the characteristics of 3D printers, there may be layer lines. ・ There may be traces of sanding on the surface. ・ Please refrain from purchasing if you are looking for a perfect finish or if you are concerned about the details. ・ The product photos are reused. Please understand.