Purchased on BOOTH in April 2025. Used for a few days. ○ Product Description This is a tilt stand specifically for the Logitech trackball MX ERGO. It is a handmade product created using a 3D printer. It allows for a 50° tilt, in addition to the standard tilt angle (20°). The tilt angle is fixed at 70°. The height from the floor to the top of the ball is approximately 103mm. The stand is installed by sandwiching it between the trackball body and the metal plate. It is held in place by magnets, so the stand will not detach even if you lift the trackball. A pin for removing the ball is stored in the stand. The USB receiver can be stored in the stand. ○ Additional Information The MX ERGO in the image is not included. Only the stand will be shipped. The appearance of 3D printed items varies. Streaks and stringing may remain, but we sell only items that have been confirmed to not cause any problems during use. Large burrs have been removed, so sanding marks may remain. The fixing strength is equivalent to the standard metal plate of the MX ERGO. Since the position of your hand will be higher when using this, we recommend using a wrist rest for a mouse, etc. ○ Specifications Printing Method: Fused Filament Fabrication (FFF) Material: PLA Body Color: Black Weight: Approximately 33g