SwitchBot Finger Robot Mount Base for Wall Light Switches ◆ Product Overview This is a mount base specifically designed for the SwitchBot Finger Robot, compatible with Panasonic Cosmo Series Wide 21 (120 x 70mm) switch plates. It can be installed on single-row switches (single-gang) or the center switch of a three-gang vertical switch. == Discounts available for multiple purchases == Please let us know in the comments section if you are interested. ☆☆ Important Note ☆☆ This product is designed based on the Panasonic "Cosmo Series Wide 21" switch plate. It is NOT compatible with square-type switch plates (see photo), so please be careful when purchasing. ◆ Product Contents (May be shipped assembled) Base x 1 Mount x 1 ※ SwitchBot unit is not included. ◆ Material PLA resin (white) A plant-based, environmentally friendly material. ※ Avoid use in high temperatures (above 40 degrees Celsius). Please use indoors. ◆ Installation Instructions 1. Combine the base and mount parts. (The parts are designed to snap together.) 2. Attach the SwitchBot unit to the mount. 3. Fit the base into the switch plate. ※ Designed to be a snug fit for secure fixation. 【Important Notes】 ・ All products are shipped after operational testing. During operation, the part that secures the SwitchBot may move slightly, but this is a design specification. If you have any problems with the operation, please contact us in the comments section before leaving a review. We will respond quickly and honestly. ・ Due to the nature of 3D printing, there may be layer lines. ・ There may be sanding marks on the surface. ・ Please refrain from purchasing if you are looking for a perfect finish or are concerned about the details. ・ The product photos are used repeatedly. Please understand.